|
|
| |
|
|
I have been Trained by the following Manufacturers:
Ioline: Studio 8, Classic series cutters.
Roland: 1100, 1200, CM 300 and PC 60 series cutters. The PC-50, 60 and 600 ColorCAMs. The CJ, FJ and SJ series Printers including the SOLJET II EX series and the Versacam (SP-300/540v). Have a lot of experience on the SC-540 units..
Mimaki: JV3 Series (S/SP 160 and 250). Have a lot of experience with the JV3s. I have been servicing Mimaki Printers for over 5 years now. Very familiar with the various bulk ink systems on these units.
Mutoh: Falcon II Outdoor and Toucan LT. series printers. Have experience with the Jr. and Gerber JETSER printer as well.
HP: ASP Certified Designjet Technician. Certified on 500, 800, 1000, 5000/5500 Series Designjets. and CP Series Designjets as well.
Encad: Do not service Encads, this is handled by Kodak techs. However, I have a lot of experience with the 850/880 Series printers as well as the 736 and VINYLJET Series.
Scanvec: Trained and proficient with the FLEXI and PHOTOPRINT families of software. Beta Tester for Release 7 and 7.5 and OSX initial release.
Wasatch: Been working with Wasatch since v 3.1.
Onyx: Have been working with Onyx for over 5 years now.
Familiar with the following color management/ICC authoring software:
Colorblind: Software was my first foray into ICC authoring.
Monaco: Mild experience with this software. Prefer this over Colorblind mainly because the Color engine is better (better gamut mapping, LUT generations ect…) and allows Linearization within the profile.
Other print/cut products with which I am familiar:
X-rite and i-ONE specrtophotometers. Anagraph cutters, Daige, GBC and Seal Laminators, Legacy CASmate, Inspire and Sign Wizard RIP/CUT software. Isis, Rasterlink Pro RIPS and Microtek Scanners.
|
 |
|
